Enclosure volume for DIY speakers

Drivers need enough air behind them, and the battery and amp take some of it. Measure the inside of the box, then subtract what you put in it.

Calculate it

Internal volume in litres = length × width × height in centimetres ÷ 1000. A box 25 × 17 × 12 cm inside is 5.1 L. In inches, multiply length × width × height by 0.0164. Subtract the battery (a 4S2P 18650 pack is about 0.3 L), the amp and wiring (about 0.1 L), and about 0.15 L per driver magnet. The planner assumes 1.5 L for electronics and wiring, which is conservative.

Common case sizes

CaseApprox. interior
Pelican 12003 L
Apache 28005 L
M2A1 .50 cal ammo can5 L
Pelican 14007 L
Apache 38008 L
Pelican 14509 L
Apache 480015 L
Pelican 155020 L

These are approximations. Measure your own case.

Sealed or ported

Small full-range builds are usually sealed: simpler, tighter bass and less to get wrong. A ported box adds output near its tuning frequency but needs the port length calculated for the box volume and driver.

3D printed enclosures

Print with 4 or more perimeters at 3 to 4 mm wall thickness so the panels don’t resonate. Use PETG or ASA: PLA softens around 55 to 60 °C, which a closed car can reach. Add heat-set inserts for screws, a foam or silicone gasket on the lid, and seal seams so the box is airtight. Large boxes can be split into panels to fit the print bed. Useful items: PETG filament, heat-set inserts.

Open the build planner